Stereo PA amplifier with SMPS, 2 x 1050 W
PSSO HSP-2100 MK2 SMPS Amplifier

L'articolo non è più disponibile.

Guarda le alternative:

No. 10451686

Features

Stereo PA amplifier with SMPS, 2 x 1050 W

Stereo PA amplifier with class H circuitry
Low weight and height due to integrated switch mode power supply
Reliable power amp with high impulse stability for a wide range of applications (e.g. compact PAs, multi-way PAs, international concerts)
Limiter and speaker switch-on delay
3 operating modes can be selected (stereo, parallel or bridged)
2 calibrated level controls for precise level adjustment
Input sensitivity and limiter adjustable
LED VU meter and LEDs for activated protective circuit (protect), overload (clip), and signal per channel
LEDs for parallel and bridge mode
Complete protection set against short-circuit, overheat, clipping, overload, DC voltage and VHF signals
Highly efficient front-to-rear air routing
Electronically balanced inputs via XLR mounting jacks, with XLR feed-through outputs
Speaker outputs via lockable Speaker plugs and screw terminals
Rugged steel chassis with aluminum front panel
Rack installation with 2 units

Dati tecnici

Alimentazione elettrica:	230 V AC, 50 Hz
Potenza totale installata:	1500,00 W
Intervallo di frequenza:	20 - 20000 Hz
Misure:	Larghezza: 48,3 cm Profondità: 40 cm Altezza: 8,9 cm
Peso:	9,95 kg
Power output (RMS):
Stereo 4 ohms	2 x 1050 W
Stereo 8 ohms	2 x 650 W
8 ohms bridged	1 x 2200 W
Signal-to-Noise ratio:	>90 dB
Total harmonic distortion:	<0.1 %
Damping factor:	>300
Voltage gain:	38 dB
Slew rate:	>20 V/µsec
Crosstalk:	>70 dB
Input sensitivity:	32 dB/1.0 V/0.775 V, swtichable
Input impedance:	20 kohms (balanced), 10 kohms (unbalanced)
Input connectors:	2 x XLR
Output connectors:	2 x Speaker, screw terminals, 2 x XLR feed-through output
Protection:	Overheat, overload, short-circuit, over-current, DC voltage, softstart, VHF signals
Cooling:	2 temperature-controlled fans, front-to-rear
Controls:	Power switch, input attenuators, mode switch stereo/parallel/bridged, input sensitivity
LED indicators:	parallel, bridge (globally), protect, clip, signal (per channel)
Construction:	Steel chassis, aluminum front panel
	Rack installation with 2 U